Designed to replace those bent or broken roller pins that have seized up over the years. A direct replacement for the original rollers. Simply cut the old one out and bolt this right back in place. Highly recommend getting the door spring tool for ease of reinstallation.
***These rollers WILL NOT hold up to a wore out arm that rides against the roller. That MUST be replaced or repaired so that it is not wore to a sharp edge. We offer the arms if you are not able to repair the factory roller***
88-98 Door Roller Spring Catch Arm
Proudly Made In The USA.
105 Reviews
-
Pulling them in
Tip: I purchased an inch and 2 inch longer bolts to reach and pull the roller section in, the knurling was too tight and I didn't want to hammer the main roller body in. Switch to each smaller bolt and it went in perfect.
-
Door pin roller
Excellent replacement solution. Straightforward install.
-
door pin rollers
super workmanship....nice product to add to my obs
-
Roller pins
Dont skip this step.... These are easily installed, and excellent quality... 10/10 will buy again
-
Door roller pin
Amazing product, easy and quick to install. The way it should have been designed from the factory.
-
Door pins
Worked like the were designed to . easy install
-
OBS Door Pin Rollers
Very high quality and the split design makes installation very easy. my door functions as intended again after years
-
Excellent quality
I tried a few other options before this one, and they all required excessive hammering or filing down the rollers to get them to fit. This one fit like a dream, and the bolt on the top means it’s super easy to get in and tighten down. Kind of expensive, but definitely the best tool for the job
-
Great quality roller pin!
My doors no longer have a crunchy sound opening and closing from bent and rusty factory roller pins. Great quality!!
