Door still popping even after you changed the roller? Typically these arms are the cause. When they wear unevenly and break your factory roller off chances are its damaged. They get wore to a "point" instead of a nice smooth rounded hill. These will not be the easiest to replace and drilling/cutting maybe required. These come with a bolt, washer, locknut, and bushing to fit the inside of the arm. Direct bolt in after the original is removed completely. Made from a stainless steel to prevent rust from happening.
Set Includes - 1 bolt, 2 washers, 1 lock nut, 1 bushing, and 1 arm
10 Reviews
-
Great product
Quality is great. Easy install. Hardest part was getting the old one off.
-
Great Product
I got the whole kit to fix the doors. It was expensive but worth every penny high-quality parts.
-
Roller Spring Catch Assy
Replacement door spring roller catch, definitely a great improvement over the OEM part. Easily serviceable.
-
89 roller spring catch
Product Very well constructed, arrived quickly and in a good package from Cunningham machine . Installed this on passenger door and resolved the irritating popping sound . If you are replacing door roller pin , do yourself a favor and replace this as well . You will not regret it .
-
Roller Spring Catch Arm
If your doing the roller pin, then do yourself a favor and get this as well, hardware is of excellent quality and the machining of this part is outstanding, you won't be replacing this part anytime soon!!
-
Great item
This is a great product, made my door open and close like New. I would surely recommend this product to anyone that has a OBS that has worn out, and noisey doors.
-
Door roller spring catch arm
Best design iv seen. Hands down . Worked perfectly
-
Roller spring catch arm
Installation was easy once you removed the old ones. Removing the old ones was the hard part. The door's work very smoothly now.
-
Installed easily
However, getting the old one out was a PIA! After I air-chiseled off the rivet, it still wouldn't drive out since the hole in the hinge had a huge chamfer in it and the old rivet was peened into it. I had to grind out the interference with a die grinder. The new one went right in and has a lot less sloppy of a fit compared to the old one. Like the roller, it can be easily replaced if needed, but I think it will last forever. Great product!
