Tie Rod Sleeve, Raw or Black Powder Coat - Steel
Fits – 1988-1998 GM 1500, 2500 and 3500, 2wd and 4wd
Fit Stock Tie Rods as well as some aftermarket
(Tie Rods NOT included)
***If using Mevotech TTX tie rod sleeves you will need go clean the powder coat off the threads on the tie rods!!!***
Set includes 2 Tie Rod Sleeves, 2 RH Nuts, 2 LH Nuts
Offroad use only, not for highway use.
All Parts Proudly Made in the U.S.A!!!
24 Reviews
-
Fit moog problem solver
I have moog problem solver tie rod ends for 99 k2500 sub. One sleeve went on practically by hand. The other I had to put in a vice to crank it on, then back it off for whatever reason. Once cranked on they were very nice. Easy to adjust and solid. Not sure why the one was being so difficult to install, but worked out well.
-
Tie Rod Sleeve
Well made heavy duty part.
-
Tie rod sleeves
Nice and beefy way better than stock look great too
-
Tie rod sleeves. 99 3/4 suburban.
Good heavy parts. Both inner tie rods and one outer tie rod was really hard to screw into the sleeve. Had to remove tie rods and put them in a vice, screw the sleeve on a little at a time backing it back out with oil. Nothing stripped. When I removed the sleeve to check threads they all looked good. I think the thread pattern was just slightly off. Stock tie rods. They’re on now and work as they should. Nice clean look. 99 3/4 suburban.
-
Tie rod sleeves
The powder coating was chipped in different spots and they were a spot that the coating was thin. I know they would eventually get chipped, but if I paid for the coating I would expect it to be delivered without damage. Other than that they are good pieces.
-
Godd quailty and works great!
Would recommend
