Fits – 1988-1998 GM 1500, 2500 and 3500, 2wd and 4wd
1983-1995 4WD S10/Blazer
1996-2004 S10/Blazer 2wd/4wd
Fit Stock Tie Rods as well as some aftermarket
(Tie Rods NOT included)
***If using Mevotech TTX tie rod sleeves you will need to clean the powder coat off the threads on the tie rods!!!***
Set includes 2 Tie Rod Sleeves, 2 RH Nuts, 2 LH Nuts
All Parts Proudly Made in the U.S.A!!!
29 Reviews
-
MUST HAVE POINT BLANK
This is a must have.. Replace those flimsy ties, for these.. Photo's do not reflect current production. Wish their gallery would improve. Current production does not have Holes on side, instead is a Solid piece.
-
Great products and customer service
Items request were sent exactly as advertised. Have had zero issues with any of them I had ordered in the past.
-
Tie rod sleeves
Very nice machined parts with nice powder coat
-
Sleeves
Good ?
-
Great product
Awesome
-
Fit moog problem solver
I have moog problem solver tie rod ends for 99 k2500 sub. One sleeve went on practically by hand. The other I had to put in a vice to crank it on, then back it off for whatever reason. Once cranked on they were very nice. Easy to adjust and solid. Not sure why the one was being so difficult to install, but worked out well.
-
Tie Rod Sleeve
Well made heavy duty part.
-
Tie rod sleeves
Nice and beefy way better than stock look great too
-
Tie rod sleeves. 99 3/4 suburban.
Good heavy parts. Both inner tie rods and one outer tie rod was really hard to screw into the sleeve. Had to remove tie rods and put them in a vice, screw the sleeve on a little at a time backing it back out with oil. Nothing stripped. When I removed the sleeve to check threads they all looked good. I think the thread pattern was just slightly off. Stock tie rods. They’re on now and work as they should. Nice clean look. 99 3/4 suburban.
